![background image](http://html2.mh-extra.com/html/rangemaster/rm51000-series/rm51000-series_user-instructions_3693931005.webp)
- 5 -
INSTALL MOUNTING
BRACKET
1. Construct wood wall
framing
that is flush
with interior surface of wall studs.
Make sure:
a) the framing is centered over
installation location.
b) the height of the framing will allow the
mounting bracket
to be secured to
the framing within the dimensions
shown.
2. After wall surface is finished, secure mount-
ing bracket to framing using dimensions
shown.
INSTALL THE DUCTWORK
NOTE: To reduce the risk of fire, use only
metal ductwork.
1. Decide where the ductwork will run
between the hood and the outside.
2. A straight, short duct run will allow the hood
to perform most efficiently.
3. Long duct runs, elbows, and transitions
will reduce the performance of the hood.
Use as few of them as possible. Larger
ducting may be required for best
performance with longer duct runs.
4. Install a roof or wall cap. Connect round
metal ductwork to cap and work back to-
wards hood location. Use duct tape to seal
the joints between ductwork sections.
FRAMING BEHIND DRYWALL
38-1/16"= bottom of hood 24"
above cooktop
44-1/16"= bottom of hood 30"
above cooktop
ROOF CAP
ROUND
DUCT
DECORATIVE
FLUE
HOOD
WALL
CAP
ROUND
ELBOW
24” TO 30” ABOVE
COOKING SURFACE
38-1/16” to 44-1/16”
above cooktop
6 ”
A D A P T E R
INSTALL THE
HOOD
1. Hang the hood from the
bracket through the
rectangular cut-out
on
the back of the hood.
Cut-out is larger than the
bracket to allow for
horizontal adjustment.
The bottom of the hood
should be 24" to 30"
above the cooking
surface.
2. Secure the hood with
mounting screws
. Use drywall anchors, provided, if wall studs or framing are
not available.
MOUNTING
SCREWS
RECTANGULAR
CUTOUT
WALL FRAMING
MOUNTING
BRACKET
MOUNTING
SCREWS
Содержание RM51000 Series
Страница 2: ......