Rangemaster Excel 110 Ceramic, Руководство пользователя и инструкция по установке, Страница: 30 / 40

30
WARNING - SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
LH oven
Pull cooker forward to gain access to the cover
box at the rear of the cooker. Remove the screws
securing the cover and lift clear.
Feed the thermostat capillary out of the oven. Disconnect
wiring from thermostat. Remove 2 screws holding
thermostat to mounting panel and the earthing plates
held to the capillary. Fit new thermostat and reassemble in
reverse order. Ensure that the phial is clipped to the oven
back with the phial centrally positioned between the clips
and the earthing plates are replaced..
Check operation of thermostat.
8. To Change Grill Controller
Lift up the ceramic hob top (see 2). Remove control
panel (see 4). Disconnect wiring from controller. Remove
2 screws holding controller to mounting panel. Fit new
controller and reassemble in reverse order. Check for correct
operation.
9. To Remove Grill Door
Remove the left hand side panel (see 1). Remove the control
panel (see 4). Remove the centre cover strip (5 screws, 2 top,
2 bottom, 1 in middle). Remove the two countersunk screws
(1 each side) securing the grill hinge arms to the front of the
grill chamber.
NOTE: The arms are spring tensioned. Carefully remove the
grill door. Retain the gaskets.
Reassemble in reverse order ensuring that the gasket is
fitted between the hinge arm and the front of the grill
chamber.
10. To Remove an Oven Door
Open oven door and remove Handyrack (where fitted)
by springing one side out of the bracket on the door and
sliding the other side free. Support the door and remove
the two screws securing the upper hinge and packing to
the cooker front. Remove the door from the lower hinge by
lifting slightly and moving outwards.
Reassemble in reverse order.
Door adjustment
Please check the aligment of the doors. The oven doors
have adjustible hinges.
To Adjust the Oven Door Angle
The door bottom hinge can be adjusted to alter the
angle of the door.
Loosen the bottom hinge fixing screws and use the
notch and a flat bladed screwdriver to move the position
of the hinge to set the hinge position.
Retighten the hinge screws.
Effect of hinge adjustment – exaggerated for clarity
Centre line of hinge pin
Oven door omitted for clarity
11. To Change Oven Door Outer Panel
Move the cooker forward to gain access to the sides.
Open the oven door slightly and remove the front panel
fixing screws from the door sides (two each side).
Carefully lift off the outer door panel.
Remove door handle from panel by unscrewing 2 retaining
nuts. Fit door handle to new panel
Fit panel to door. Reassemble in reverse order.
12. To Change Oven Door Latch
Remove outer door panel (see 15). Remove screws ‘B’
holding latch assembly to inner door panel. Fit new catch
and reassemble in reverse order.
Check correct door operation.
13. To Change Oven Door Seal
Open oven door. The seal is held in place by small hooks on
the rear face. At the corner pull seal diagonally away from
the door centre until that hook is released. Proceed to the
next hook and release it in a similar way, and so on. Use
force if the hooks are stiff, as the old seal will be discarded.