WATER FILLING AND HEATING
Picture 1
A Main switch
B
Lamp “machine on”
C
Lamp “machine ready”
D
Lamp “cycle on”
E Boiler thermometer
With reference to picture 1, the appliance is switched on by turning the main switch (
A
) clockwise
into position (1); at the same time the warning lamp (
B
) lights on.
The appliance automatically fills water into the tank up to the set level and it switches on the boiler
and tank heating elements. When the right temperatures are achieved, the lamp (
C
) lights on, so to
show that the appliance is ready for starting the washing cycle. Check that the boiler thermometer
(
E
) is at the pre-set temperature.
N.B.
The internal thermostats are set by the manufacturer at the following temperatures:
·
boiler water temperature:
82,5 °C
;
·
tank water temperature:
55 °C
.
WASHING CYCLE
·
Lift up the hood of the appliance and pour some detergent into the tank (except for versions with
built-in detergent dispenser). The tank capacity is of 20 litres; therefore, the detergent shall be
poured into according to its manufacturer's prescriptions.
·
Remove all the solid remainders from the dishes and put them inside the baskets.
·
Select the washing cycle simply by turning the main switch (
A
). If it is in position (2), the
appliance will carry out the short cycle; if it is in position (3), it will carry out the long cycle; if it
is in position (4), it will work continuously, a washing cycle that is suitable for very dirty dishes
and glasses. In this last case it is necessary to turn the switch in position (3) or (2) in order to stop
washing and pass to the rinsing cycle.
·
Slide the basket into the appliance and lower its hood. The appliance automatically starts the
washing and then the rinsing cycle, as shown by the lamp (
D
), starting also the rinse aid
80
c
9
0
1
2
3
4
5
A
D
C
B
E
18
