Manual-1
ML 1
MIC/LINE PREAMP
OPERATORS MANUAL
Quick Start
This section intends to help with the physical connections neces-
sary to get up and running with your snazzy new ML 1. If you
don’t read this entire manual, at least read this section.
As a safety precaution, turn all devices (especially power
amplifiers)
off
when making connections. Doing so gives you a
chance to find and correct wiring mistakes and prevent damage
to your amplifiers, speakers, ears and spilling a hot drink in your
lap.
Connect balanced audio sources or microphones to the
Euroblock or XLR INPUT connectors. You may connect either
or both jack types (if you wish) of the OUTPUTS to your mixer,
recorder or amplifier. Set the GAIN control to the half-way
(12:00) position. Set the MIC / LINE switch to “LINE” for a
WEAR PARTS:
This product contains no wear parts.
ML 1
MIC / LINE
PREAMP
SIGNAL
1
2
OVERLOAD
POWER
1
2
gain of +3 dB, or to the “MIC” position for a gain of +35 dB. If
a microphone requires phantom power, punch in the “PHAN-
TOM POWER” switch and the corresponding red LED will
light up.
If the ML 1 is being used as a dual analog preamp, connect
balanced audio OUTPUTS to the Euroblock or XLR connec-
tors. To talk to the digital audio world, connect to your choice of
AES3, SPDIF or TOSLINK digital audio outputs.
Connect the IEC320-C5 power cord. Observe that the
POWER LED on the front panel illuminates.
Now you may turn on any power amps and make final ad-
justments with the GAIN controls.
