R&S ZNL, Руководство пользователя

Страница: 89 / 1135

Operating modes, applications, channel setups, and result displays
R&S
®
ZNL/ZNLE
89 User Manual 1178.5966.02 ─ 19
Note: The channel setups are labeled with the application name. If that name already
exists, a sequential number is added. You can change the name of the channel setup
by double-tapping the name in the channel setup bar and entering a new name.
For an overview of default names see
INSTrument:LIST?
on page 570.
Remote command:
INSTrument:CREate[:NEW]
on page 569
INSTrument[:SELect]
on page 571
Replace Current Channel Setup ← Defining a channel setup
The application selected on this tab of the dialog box is started in the currently dis-
played channel setup, replacing the current measurement.
Remote command:
INSTrument:CREate:REPLace
on page 569
Duplicate Current Channel Setup ← Defining a channel setup
The currently active channel setup can be duplicated, i.e. a new channel setup of the
same type and with the identical measurement settings is started. The name of the
new channel setup is the same as the copied channel setup, extended by a consecu-
tive number (e.g. "Spectrum" -> "Spectrum 2" ).
Remote command:
INSTrument:CREate:DUPLicate
on page 568
Closing a channel setup
To close a channel setup, simply close the corresponding tab by selecting the "x" next
to the channel setup name.
Remote command:
INSTrument:DELete
on page 569
5.4 Running a sequence of measurements
Only one measurement can be performed at any time, namely the one in the currently
active channel setup. However, in order to perform the configured measurements con-
secutively, a Sequencer function is provided.
● The sequencer concept ...........................................................................................89
● Sequencer settings ................................................................................................. 92
● How to set up the sequencer .................................................................................. 92
5.4.1 The sequencer concept
The instrument can only activate one specific channel setup at any time. Thus, only
one measurement can be performed at any time, namely the one in the currently active
channel setup. However, in order to perform the configured measurements consecu-
tively, a Sequencer function is provided, which changes the channel setup of the instru-
ment as required. If activated, the measurements configured in the currently defined
"Channel"s are performed one after the other in the order of the tabs.
Running a sequence of measurements