R&S ZNL, Руководство пользователя

Страница: 414 / 1135

VNA GUI reference
R&S
®
ZNL/ZNLE
414 User Manual 1178.5966.02 ─ 19
See Chapter 10.7.1.3, "Balanced Ports dialog" , on page 398.
10.7.8 Power Sensor tab
R&S ZNL only
Allows you to set up and perform measurements using external power sensors.
The standard test setup for a "Power Sensor" measurement involves one analyzer
source port and a power sensor. The power sensor is connected to the VNA (e.g. to
the analyzer's USB port) and provides scalar wave quantity results. See
Chap-
ter 9.7.14, "Power sensor measurements (R&S ZNL only)" , on page 306.
Some buttons serve as openers for additional dialogs:
●
"Cal Power...": see Chapter 10.12.3.2, "Cal Power Config dialog" , on page 512
●
"Transm. Coefficients...": see Chapter 10.12.3.3, "Power Meter Transmission Coef-
ficients dialog" , on page 514
●
"Power Meters...": see Chapter 9.7.14, "Power sensor measurements (R&S ZNL
only)" , on page 306
●
"Power Meter Config...", see Chapter 10.12.3.5, "External Power Meter Config dia-
log" , on page 520
This button is active only if at least one external power meter is online (physically
connected, switched on, ready to be used).
Pmtr<i>
After a power meter was connected, configured , and selected , you can use this button
to create a power meter trace in one of the available diagrams or in a new one.
Remote command:
CALCulate<Ch>:PARameter:MEASure 'TraceName', 'PmtrD1 | ...
CALCulate<Ch>:PARameter:SDEFine 'TraceName', 'PmtrD1 | ...
Meas softtool