R&S ZNH, Руководство пользователя

Страница: 43 / 369

Basic Operation
R&S
®
ZNH
36 User Manual 1334.5985.02 ─ 02
Parameter Description
"Points" Configure the number of measurement points.
See Chapter 8.3.4.1, "Changing the Number of
Measurement Points" , on page 162.
"Avg" Toggle the trace parameter to select the different
trace mode ("OFF", "ON").
See Chapter 8.4.1, "Working with Traces" ,
on page 164.
"Suppr" Configure the smoothing mode to suppress signal
resulting from interference source
See Chapter 8.4.1.3, "Selecting Suppressing Inter-
fering Signals" , on page 164.
"Aperture" Selectable only when smoothing mode is activated.
Configure the aperture size used in the measure-
ment.
See Chapter 8.4.1.3, "Selecting Suppressing Inter-
fering Signals" , on page 164.
"Config Overview" Display the configuration overview window for more
configuration options used in the measurement.
Configuration overview is operation mode depend-
ent.
See Chapter 4.1.6, "Configuration Overview" ,
on page 36.
4.1.6 Configuration Overview
There is a dedicated button located at the bottom right-hand corner of the parameter
view. It is operation mode dependent. See
Figure 4-1 .
When you select this button, it opens the configuration overview window. Accessing it
without the touchscreen input is possible via the [SETUP] key. See
Chapter 5.5, "Con-
figuring Measurements" , on page 83.
The configuration overview window illustrates here shows the flow of a vector network
measurement (VNA) at different stages and the relevant parameters which have an
impact on the measurement at each stage.
Screen Layout and Elements