Command Reference
R&S
®
ZNC
473
User Manual 1173.9557.02 ─ 13
.
Parameters:
<Boolean>
ON - the limit line colors are defined via
DISPlay:CMAP<DispEl>:RGB
where
<DispEl>
= 9 ... 12. The
limit line colors are independent of the trace colors.
OFF - all limit lines have the color of the associated trace.
*RST:
n/a (a *RST does not affect the setting). In the factory
configuration, OFF is preset.
Example:
DISP:CMAP:LIMit OFF
Use the trace colors for all limit lines associated with each trace.
Subsequent limit line color definitions will be ignored until individ-
ual limit settings are enabled again.
DISPlay:CMAP:LIMit:FCOLorize:STATe ON
Assign a different trace color to failed trace sections.
DISPlay:CMAP:LIMit:FSYMbol:STATe OFF
Remove the limit fail symbols from the trace.
Manual operation:
See
"Limit Test > Use Trc Color for Limit Lines"
DISPlay:CMAP:MARKer[:STATe]
<Boolean>
Displays all markers with the same color or display each marker with the color of the
associated trace. The colors of all display elements are defined via
DISPlay:CMAP<DispEl>:RGB <Red>, <Green>, <Blue> ...
Parameters:
<Boolean>
ON - all markers have the same color, to be defined via
<Red>, <Green>, <Blue>
.
The marker color is independent of the trace colors.
OFF - each marker has the color of the associated trace.
Example:
See
Manual operation:
See
"General > Same Color all Markers"
DISPlay:CMAP<DispEl>:RGB
<Red>, <Green>, <Blue>[, <TraceStyle>,
<TraceWidth>]
Defines the color of all display elements based on the Red/Green/Blue color model.
Suffix:
<DispEl>
.
Number of the display element. The display elements correspond-
ing to the numbers 1 to 20 are listed below.
Parameters:
<Red>
Red content of the defined color.
Range:
0 (zero intensity, corresponding to a 0 in the 24-bit
color model) to 1 (full intensity, corresponding to 255
in the 24-bit color model).
SCPI Command Reference
