GUI Reference
R&S
®
ZNC
197
User Manual 1173.9557.02 ─ 13
Ref Mkr -> Mkr
Places the reference marker to the position of the active marker. "Ref. Mkr -> Mkr" is not
active if the active marker is a reference marker.
Remote command:
n/a
Export Markers
Calls up a "Save As"... dialog to store the current marker values to a marker file.
The analyzer uses a simple ASCII format to export marker values. By default, the marker
file extension is
*.txt
. The file contains all traces in the active recall set together with
their names and measured quantities. Below each trace, the file shows a list of all markers
with their names, stimulus and response values.
The following example of a marker file describes a recall set with two traces, "Trc1" and
its memory trace "Mem2[Trc1]". "Trc1" has a reference marker "R" and three normal
markers "M1, M2, M3" assigned, the memory trace has no markers.
Remote command:
Decimal Places
Opens the "System Config" dialog to define the (maximum) number of fractional digits
for setting values and measurement results. See also
chapter 4.6.2.3, "User Interface"
4.2.6.3
Marker > Marker Search
The "Marker Search" functions use markers to locate specific points on the trace. The
functions are unavailable if the active trace contains no markers (e.g. after "All Markers
Off").
The marker search extends over a configurable range of stimulus values ("Search
Range..."). In the default configuration, the search range is equal to the entire sweep
range.
Background information
Refer to
Access:
TRACE > MARKER key or Alt + Shift + G
Trace Settings
