GUI Reference
R&S
®
ZNB/ZNBT
342
User Manual 1173.9163.02 ─ 55
The limit line colors are defined in the
Define User Color Scheme Dialog
[DISPLAY] > "Config" > "Define User Color..."). You can choose between various
options:
●
Display upper and lower limit lines with different colors.
●
Assign the same color to traces and associated limit lines.
●
Assign different colors to limit line segments with disabled limit check.
Note:
Display of the limit line and limit check are independent of each other: Hiding the
limit line does not switch off the limit check.
Remote command:
CALCulate<Chn>:LIMit:DISPlay[:STATe]
Limit Check
Enables/disables the limit check for the active trace.
If enabled, an additional info field is displayed in the diagram, indicating the "PASS" or
"FAIL" state. Limit violations are marked with a colored square. An acoustic signal
(
) and a TTL signal indicating pass or fail can be generated in addition.
The "Limit Fail Trace Color" and the appearance of the limit fail symbols are defined in
the
Define User Color Scheme Dialog
("Display" > "Config" > "Define User Color...").
Note:
●
Limit check and display of limit lines are independent of each other:
–
The limit lines can be displayed, no matter if the limit check is enabled.
Lines Softtool
