R&S TSMA6, Руководство пользователя

Страница: 13 / 155

Instrument Tour
R&S
®
TSMA6
13 User Manual 4900.8057.02 ─ 06
WLAN/Bluetooth ON/OFF
Switches WLAN and Bluetooth on and off.
SCAN (LAN Connector (Gbit))
The LAN connector provides a high-speed 1 Gbit Ethernet interface with an RJ 45 con-
nector. It is used to connect the R&S
TSMA6 to a separate R&S TSME6 as a second
scanner. It can be used for MIMO scenarios and for increasing bandwidth and mea-
surement rate.
AUX Connector
The AUX connector has two functions.
●
IN/OUT synchronization with up to 4 connected R&S TSME6 (requires sync cable
R&S TSME6-ZC2, R&S no. 4900.1800.02 or R&S TSME6-ZC4, R&S no.
4900.1817.02)
●
Synchronization of R&S TSMA6 with an external 10 MHz reference (requires dedi-
cated sync cable)
GPS Ant.
An SMA connector is provided for the supplied external active GPS antenna (Antenna
power: 3
V, max. 25 mA).
The integrated multi-GNSS (GPS / BeiDou / Galileo / GLONASS) receiver allows to
use three satellite systems in parallel. This offers an accuracy improvement of 30 % to
50 % by using a second constellation of satellites.
Following combinations are allowed:
●
GPS only
●
GPS / GLONASS / Galileo
●
GPS / BeiDou
The R&S TSMA6 can perform dead reckoning in tunnels to provide position informa-
tion even if no satellites are available. The dead reckoning is performed in the device
itself by built-in electronic gyroscopes.
For enabling untethered dead reckoning, see Chapter 5.8, "Enabling Untethered Dead
Reckoning " , on page 31.
Depending on the intended use, the respective valid regulations regarding lightning
protection of the antennas and regarding vehicle installation must be observed during
installation.
Status LEDs
The four status LEDs, [Scanner State], [Scanner Pwr], [Mode], and [Meas] indicated
different states of the R&S
TSMA6. For a detailed description, see Chapter 3.3, "Status
LEDs" , on page 15.
Rear Panel View