Getting Started
Satellite Navigation
23
User Manual 1178.6379.02 ─ 01
6. To observe current satellite constellation, select "GNSS > Simulation Monitor".
7. To reconfigure the satellites constellation, select "Simulation Monitor > Config".
8. In the block diagram, select "RF > On".
The signal generation starts.
The frequency and level of the generated RF signal are configured automatically.
Further settings are not required.
For description of the related settings, see:
●
Chapter 5.2, "General Settings"
●
Chapter 5.3, "Simulation Monitor"
●
Chapter 8, "Satellite's Constellation"
5.2 General Settings
Access:
► Select "Baseband > Satellite Navigation > GNSS".
This dialog comprises the standard general settings.
The remote commands required to define these settings are described in
Settings:
General Settings