R&S SMJ100A, Руководство по эксплуатации, Страница: 774 / 874

Remote Control Commands
R&S
®
SMJ100A
758 Operating Manual 1403.7458.32 ─ 14
Example: SOUR:LIST:TRIG:EXEC
triggers the processing of the selected list.
Usage: Event
Manual operation: See "Execute Single - List Mode" on page 275
[:SOURce<hw>]:LIST:TRIGger:SOURce <Source>
Selects the trigger source processing lists.
The names of the parameters correspond to those under sweep mode. SCPI uses
other names for the parameters; these names are also accepted by the instrument.
The SCPI names should be used if compatibility is an important consideration. An
overview of the various names is given in the following table:
R&S name SCPI name Command under manual con-
trol
AUTO IMMediate MODE AUTO
SINGle BUS
MODE SINGLE
or
STEP
EXTernal EXTernal
MODE EXT TRIG SINGLE
or
EXT TRIG STEP
Parameters:
<Source> AUTO | IMMediate | SINGle | BUS | EXTernal
AUTO|IMMediate
The trigger is free-running, i.e. the trigger condition is fulfilled
continuously. The selected list in List mode is restarted as soon
as it is finished.
SINGle|BUS
The list is triggered by the GPIB commands
[:SOURce<hw>]:
LIST:TRIGger:EXECute
. The list is executed once.
EXTernal
The list is triggered externally via the INST TRIG connector. The
list is executed once.
*RST:
AUTO
Example: LIST:TRIG:SOUR EXT
selects triggering by means of the external trigger.
Manual operation: See "Mode - List Mode" on page 274
7.16.12 SOURce:MODulation Subsystem
This subsystem contains the command for switching on/off all modulations.
[:SOURce<hw>]:MODulation[:ALL][:STATe] <State>
Activates/deactivates the modulations.
SOURce Subsystem