R&S SMJ100A, Руководство по эксплуатации, Страница: 601 / 874

Remote Control Commands
R&S
®
SMJ100A
585 Operating Manual 1403.7458.32 ─ 14
Parameters:
<Output> 0 | 1 | OFF | ON
ON
The signal calculation starts simultaneously with the external
trigger event but because of the instrument’s processing time
the first samples are cut off and no signal is outputted. After
elapsing of the internal processing time, the output signal is syn-
chronous to the trigger event.
OFF
The signal output begins after elapsing of the processing time
and starts with sample 0, i.e. the complete signal is outputted.
This mode is recommended for triggering of short signal sequen-
ces with signal duration comparable with the processing time of
the instrument.
*RST:
ON
Example: BB:ARB:TRIG:SOUR EXT
sets external triggering.
BB:ARB:TRIG:EXT:SYNC:OUTP ON
enables synchronous output to external trigger
Manual operation: See "Sync. Output to External Trigger" on page 380
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut:DELay:FIXed <Fixed>
The command restricts the marker delay setting range to the dynamic range. In this
range the delay can be set without restarting the marker and signal. If a delay is
entered in setting ON but is outside this range, the maximum possible delay is set and
an error message is output.
The setting always affects every marker.
Parameters:
<Fixed> 0 | 1 | OFF | ON
*RST:
0
Example: BB:ARB:TRIG:OUTP:DEL:FIX ON
restricts the marker signal delay setting range to the dynamic
range.
Manual operation: See "Fix marker delay to current range " on page 389
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:DELay <Delay>
Sets the delay between the signal on the marker outputs and the start of the signals.
SOURce Subsystem