R&S SMJ100A, Руководство по эксплуатации, Страница: 541 / 874

Remote Control Commands
R&S
®
SMJ100A
525 Operating Manual 1403.7458.32 ─ 14
Return values:
<Frequency> float
Range:
0 to max
Increment: 0.001
*RST:
0
Example: CLOC:INP:FREQ?
queries the measured frequency of the external clock reference.
Usage: Query only
Manual operation: See "Measured External Clock" on page 367
:CLOCk:INPut:SLOPe <Slope>
Sets the active slope of an externally applied clock signal at the CLOCK connector.
Parameters:
<Slope> NEGative | POSitive
*RST:
POSitive
Example: CLOC:INP:SLOP NEG
The active slope of the external clock signal is the falling slope.
Manual operation: See "Clock Input Slope" on page 143
:CLOCk:OUTPut:MODE <Mode>
Sets the output of bit or symbol clock pulses at the CLOCK OUT connector at the rear
panel.
Parameters:
<Mode> SYMBol | BIT
*RST:
SYMBol
Example: CLOC:OUTP:MODE SYMB
The internal symbol clock is output.
Manual operation: See "Clock Output Mode " on page 143
:CLOCk:OUTPut:SOURce <Source>
Queries the path for which the clock signal at the CLOCK OUT connector is to be out-
put.
Parameters:
<Source> A
*RST:
A
CLOCk Subsystem