R&S SMCVB-KB106, Начало работы

Страница: 22 / 79

Preparing for Use
R&S
®
SMCV100B
22 Getting Started 1432.7046.02 ─ 02
4.10 Connecting to RF 50
Ω
The connector is located on the front panel .
To prepare for connecting to "RF 50
Ω
"
1. If the R&S SMCV100B is switched on, deactivate the RF output, before con-
necting an RF cable to the "RF 50
Ω
" connector.
In the block diagram, select the block "RF" > "RF Level" > "RF ON > Off".
2. Use a high-quality RF cable that matches the RF connector type.
See "Cable selection and electromagnetic interference (EMI)" on page 18.
To connect to non-screwable connectors (BNC)
► To connect the RF cable with the ""RF 50
Ω
"" connector, proceed as follows:
a) Carefully align the connector of the cable and the ""RF 50
Ω
"" connector
along a common axis.
b) Mate the connectors along the common axis until the male pin of the con-
nector of the cable engages with the female socket of the ""RF 50
Ω
"" con-
nector.
Preventing RF output switch-off
► NOTICE! If you set a too high output level, the reverse power can exceed a
limit forcing the R&S SMCV100B to switch off the RF output.
Set an RF output level that is not higher than the maximum permissible RF
power as given in the data sheet.
4.11 Connecting to Ref In/Ref Out
The connector is located on the rear panel .
To connect to "Ref In"/"Ref Out" (reference < 1 GHz)
For connection, the R&S SMCV100B provides BNC connectors.
► Follow the instructions in "To connect to non-screwable connectors (BNC)"
on page 22.
Connecting to Ref In/Ref Out