R&S SMBV100B, Начало работы

Страница: 36 / 89

Instrument Tour
R&S
®
SMBV100B
34 Getting Started 1423.1049.02 ─ 02
●
Firmware update
Note: Further USB interface type A (host USB) and a USB interface type B (USB
In) are available on the rear panel.
See also
Chapter 3.2, "Connecting USB Devices" , on page 23.
Sensor
Connector for R&S NRP sensors.
A power sensor is connected to the R&S
SMBV100B by inserting the male con-
nector. To disconnect, pull the connector by its sleeve. You cannot disconnect the
sensor simply by pulling at the cable or the rear part of the connector.
The R&S
SMBV100B supports the use of R&S NRP power sensors in various
ways including the use as a power viewer.
User x
Multipurpose connectors. The input/output signal has to be defined.
The
Table 4-7 lists the signals assigned to the User x connectors in the default
instrument state.
Table 4-7: Default configuration of the User x connectors
User connector Direction Default assigned signal
1 Output Baseband Marker 1
2 Output Baseband Marker 2
See also chapter "Global Connector Settings" in the user manual.
RF
Output for RF signal.
NOTICE! Maximum input levels. Do not overload the RF output. The maximum
permissible back-feed is specified in the data sheet.
The connector type depends on the installed frequency option, see
Table 4-8 .
Table 4-8: Overview of RF connector types depending on the frequency range
Required option Connector type
R&S SMBVB-B103/-KB106 N female
NOTICE! Risk of RF connector and cable damage. If you tighten the connectors
too strongly, you can damage the cables and connectors. If you do not tighten the
connectors enough, the measurement results can be inaccurate.
Front Panel Tour