R&S SGU100A, Начало работы

Страница: 20 / 60

Preparing for Use
R&S
®
SGU100A
18 Getting Started 1418.2070.02 ─ 08
2.2 Linux Operating System
The instrument uses an embedded Linux operating system, optimally adapted to
the instrument.
Accessing the operating system
No access to the operating system is required for normal operation.
All necessary system settings can be made in the "Setup" dialog.
2.3 Connecting an External PC and Devices
As a rule, the R&S SGU is operated exclusively via remote control on a connec-
ted PC. Another way to control the instrument is the manual operation via the
R&S SGMA-GUI software on the connected PC.
Both the remote control and the manual operation of the instrument require an
external controller. For the prerequisites and the instructions on how to configure
an external controller for remote control, refer to the user manual. A brief intro-
duction to the remote control capabilities is provided in
Chapter 5.2, "Network and
Remote Control Operation" , on page 46.
This section gives an introduction on how to configure the external PC for manual
operation (see
Chapter 2.3.1, "Installing the R&S SGMA-GUI Software" ,
on page 19).
In addition to connecting an external controller, it may be useful to connect other
external devices, e.g. a memory stick. The following interfaces are provided on
the rear panel of the instrument, see also
Chapter 3.2, "Rear Panel Tour" ,
on page 30:
●
PCI Express (refer to Chapter 2.3.3, "Connecting a Controller via PCI
Express" , on page 24
●
USB interface (refer to Chapter 2.3.4, "Connecting a Controller or a USB
Device via USB" , on page 25)
●
LAN interface (refer to Chapter 2.3.2, "Connecting a Remote PC via LAN" ,
on page 20)
Connecting an External PC and Devices