R&S SGT100A, Руководство пользователя

Страница: 66 / 593

Instrument Tour
R&S
®
SGT100A
35 User Manual 1176.8674.02 ─ 07
For details, see "To connect the AC supply" on page 22.
3.3 Connector Extension Unit (R&S SGT-B88)
The R&S SGT connector extension unit can be ordered together with an R&S SGT.
The extension unit provides a front panel N-connector for the RF output and rear panel
BNC connectors for the I , Q IN, REF / LO IN, REF / LO OUT and the USER 2 connec-
tors.
The R&S SGT- B88 cannot be retrofitted on an already existing R&S SGT unit. It is
only available as a set together with a new R&S SGT instrument.
3.3.1 Front Panel
This section provides an overview of the connectors on the front panel of the extension
unit.
For an overview of the front panel connectors of the R&S SGT, refer to Chapter 3.1,
"Front Panel Tour" , on page 30.
Figure 3-3: Front panel view of the R&S SGT and the connector extension unit
RF OUT
An N-connector, that provides an RF 50 Ohm signal output.
NOTICE! Maximum input levels. Do not overload the RF output. The maximum permis-
sible back-feed is specified in the data sheet.
3.3.2 Rear Panel
This section provides an overview of the connectors on the rear panel of the extension
unit.
For an overview of the connectors of the rear panel of R&S SGT, refer to Chapter 3.2,
"Rear Panel Tour" , on page 32.
Connector Extension Unit (R&S SGT-B88)