Instrument Tour
R&S
®
RTM2000
22
Getting Started 1317.4710.02 ─ 05
Note: If another marker is available at the right, but currently not visible on the screen,
a small red arrow is displayed at the right edge of the display.
PREV
Moves the previous (left) marker to the reference point of the display or zoom area. If a
search is enabled, the key navigates the search result markers.
Note: If another marker is available at the left, but currently not visible on the screen, a
small red arrow is displayed at the left edge of the display.
SET CLEAR
Sets a new marker at the reference point of the display, or deletes an existing marker
at this point. Use the NEXT and PREV keys to move the markers to the reference
point.
In the display of search results, the marker is set to or removed from the search result
that is selected in the "Event Table".
SEARCH
Opens the "Search" menu, where you can perform a search for various events in an
acquisition - for example, peaks or specific width conditions - and analyze the search
results.
ACQUISITION
Opens the "Acquisition" menu. Here you control the data processing - how the wave-
form is built from the captured ADC samples. The current acquisition mode is shown in
the top information bar; it is the second value from right.
3.1.8 Input Channels
Input channels are the connectors for active and passive probes. The input impedance
is selectable, the values are 50
Ω
and 1
M
Ω
.
Risk of injury
If the input voltages are higher than 30
V
RMS or 42
V
peak or 60
V
DC, use appropri-
ate protective measures to preclude direct contact with the measurement setup.
Front Panel
