R&S NRP2, Руководство пользователя

Страница: 270 / 437

Remote Control - Commands
R&S
®
NRP2
252 User Manual 1173.9157.02 ─ 03
Parameters:
<NRf> {, <NRf>} Enters offset values in the second column of the table selected
with
MEM:TABL:SEL
.
*RST: Tables are not changed in case of a *RST.
Default unit: DB
MEMory:TABLe:GAIN:POINts?
Returns the number of entries (lines) in the table selected with
MEM:TABL:SEL
<string>
.
Usage: Query only
MEMory:TABLe:MAP <string>, 1...9
The numbers 0 to 9 are permanently assigned to the memory locations for device states.
Names (
<string>
) can be assigned to the numbers with
MEM:TABL:MAP
. The
MEM:CLE[:NAME]
,
MEM:TABL:MOVE
and
MEM:TABL:SEL
commands expect these
names as parameters, not the numbers of the memory locations. By default the tables
are assigned the names "Table 1" to "Table 10". The name can contain the characters
"A" to "Z", "a" to "z", "0" to "9" and "_".
The query form of this command returns the number of the memory location with the
name <map>.
Parameters:
<string>, 1...9 maps the string on the selected memory locations for device
states.
MEMory:TABLe:MOVE <string>,<string>
This command allows tables to be renamed. The first parameter specifies the old name,
the second the new name. No data is copied, i.e. only the name of the table changes.
Example: MEM:TABL:MOVE "Table 1","Test setup"
Renames the table
"Table 1"
into
"Test setup"
.
Usage: Setting only
MEMory:TABLe:RESet
The command clears all tables for frequency dependent offset.
Usage: Event
MEMory:TABLe:SELect <name>
Selects a table.
MEMory