R&S FSV-K8, Руководство по эксплуатации, Страница: 44 / 135

Instrument Functions for Bluetooth Measurements (K8)
R&S
®
FSV-K8
44 Operating Manual 1176.7610.02 ─ 02
Principally, setting the channel number has the same effect as changing the center fre-
quency. The major difference is that the center frequency is not limited to available fre-
quency band values, i.e. values outside the frequency band and between the discrete
channels can be selected (see also
Center softkey in the "Frequency" menu).
Remote command:
CONFigure:
​
BTOoth:
​
CHANnel
​
on page 94
Meas Setup ← Carr Freq Drift
Opens a dialog box for common measurement settings, see "Meas Setup" on page 36.
Find Sync ← Carr Freq Drift
Opens a dialog box to set the signal processing functions of the analyzer, see "Find
Sync" on page 37.
Zoom (Modulation Char, Init Carr Freq Tol, Carr Freq Drift) ← Carr Freq Drift
Activates or deactivates the zoom function. Opens an edit dialog box to enter the zoom
start position. The valid value range for the zoom start position is 0 to (measurement
time – 500 / sampling rate). The default setting for the zoom function is 0s (off).
With active zoom function, an area of only 501 samples is displayed.
Remote command:
[SENSe:
​
]ADEMod:
​
ZOOM[:
​
STATe]
​
on page 119
[SENSe:
​
]ADEMod:
​
ZOOM:
​
STARt
​
on page 120
Rel TX Power
Opens a submenu to configure the Rel TX Power measurement. For further details
refer to
chapter 3.1.6, "Relative Transmit Power (EDR) Measurement" , on page 28.
Remote command:
CONF:BTO:MEAS RTP
, see
CONFigure:
​
BTOoth:
​
MEASurement
​
on page 96
CALCulate<n>:
​
BTOoth:
​
RTPower:
​
[DPSK]?
​
on page 85
CALCulate<n>:
​
BTOoth:
​
RTPower:
​
GFSK?
​
on page 86
CALCulate<n>:
​
BTOoth:
​
RTPower:
​
RATio?
​
on page 87
Channel ← Rel TX Power
Opens an edit dialog box to enter the transmission channel number. From the number
of the channel the center frequency is calculated in accordance to the RF Test Specifi-
cation. The default setting is channel number 0.
Principally, setting the channel number has the same effect as changing the center fre-
quency. The major difference is that the center frequency is not limited to available fre-
quency band values, i.e. values outside the frequency band and between the discrete
channels can be selected (see also
Center softkey in the "Frequency" menu).
Remote command:
CONFigure:
​
BTOoth:
​
CHANnel
​
on page 94
Meas Setup ← Rel TX Power
Opens a dialog box for common measurement settings, see "Meas Setup" on page 36.
Softkeys of the Bluetooth Menu