R&S FSMR3000, Руководство пользователя, Страница: 644 / 733

Remote Commands
R&S
®
FSMR3000
644 User Manual 1179.0116.02 ─ 02
●
Chapter 11.2.2.12, "STATus:QUEStionable:POWer Register" , on page 333
●
Chapter 11.2.2.13, "STATus:QUEStionable:TEMPerature Register" , on page 334
●
Chapter 11.2.2.14, "STATus:QUEStionable:TIMe Register" , on page 334
● General Status Register Commands .................................................................... 644
● Reading Out the CONDition Part .......................................................................... 644
● Reading Out the EVENt Part .................................................................................645
● Controlling the ENABle Part ..................................................................................645
● Controlling the Negative Transition Part ............................................................... 646
● Controlling the Positive Transition Part ................................................................. 647
12.9.1 General Status Register Commands
STATus:PRESet
.............................................................................................................644
STATus:QUEue[:NEXT]?
................................................................................................ 644
STATus:PRESet
This command resets the edge detectors and
ENABle
parts of all registers to a defined
value. All
PTRansition
parts are set to
FFFFh
, i.e. all transitions from 0 to 1 are
detected. All
NTRansition
parts are set to 0, i.e. a transition from 1 to 0 in a
CONDition
bit is not detected. The
ENABle
part of the
STATus:OPERation
and
STATus:QUEStionable
registers are set to 0, i.e. all events in these registers are not
passed on.
Usage: Event
STATus:QUEue[:NEXT]?
This command queries the most recent error queue entry and deletes it.
Positive error numbers indicate device-specific errors, negative error numbers are error
messages defined by SCPI. If the error queue is empty, the error number 0, "No error",
is returned.
This command is identical to the
SYSTem:ERRor[:NEXT]?
command.
Usage: Query only
12.9.2 Reading Out the CONDition Part
STATus:OPERation:CONDition?
STATus:QUEStionable:CONDition?
STATus:QUEStionable:ACPLimit:CONDition?
<ChannelName>
STATus:QUEStionable:EXTended:CONDition? <ChannelName>
STATus:QUEStionable:EXTended:INFO:CONDition? <ChannelName>
STATus:QUEStionable:FREQuency:CONDition? <ChannelName>
STATus:QUEStionable:LIMit<n>:CONDition? <ChannelName>
STATus:QUEStionable:LMARgin<n>:CONDition? <ChannelName>
Using the Status Register