LTE Multi Evaluation Measurement
R&S
®
CMW-KM5xx/-KS5xx
649
User Manual 1173.9628.02 ─ 16
<Band1>
150,200
First channel bandwidth in 0.1 MHz
<Band2>
100,150,200
Second channel bandwidth in 0.1 MHz
For <Band1> = 150, only <Band2> = 150 is allowed
For <Band1> = 200, all <Band2> values are allowed
Parameters:
<Enable>
OFF | ON
OFF
: disables the check of these requirements
ON
: enables the check of these requirements
*RST:
ON (<no> = 1 to 4) / OFF (<no> = 5 to 12)
<FrequencyStart>
Start frequency of the area, relative to the edges of the aggrega-
ted channel bandwidth
Range:
0 MHz to 45 MHz
*RST:
depends on the suffixes
Default unit: Hz
<FrequencyEnd>
Stop frequency of the area, relative to the edges of the aggrega-
ted channel bandwidth
Range:
0 MHz to 45 MHz
*RST:
depends on the suffixes
Default unit: Hz
<Level>
Upper limit for the area
Range:
-256 dBm to 256 dBm
*RST:
depends on the suffixes
Default unit: dBm
<RBW>
K030 | K100 | M1
Resolution bandwidth to be used for the area
K030
: 30 kHz
K100
: 100 kHz
M1
: 1 MHz
*RST:
K030 (<no> = 1) / M1 (<no> = 2 to 12)
Example:
See
Firmware/Software:
V3.2.70
V3.2.80: <no> of areas enhanced to 12
Options:
R&S CMW-KM502/-KM552 for FDD/TDD
CONFigure:LTE:MEAS<i>:MEValuation:LIMit:SEMask:LIMit<no>:CAGGregation:
OCOMbination
<Enable>, <FrequencyStart>, <FrequencyEnd>, <Level>,
<RBW>
Defines general requirements for the emission mask area <no>. The activation state,
the area borders, an upper limit and the resolution bandwidth must be specified.
Command Reference
深圳德标仪器
135-1095-0799