R&S AREG800A, Руководство пользователя

Страница: 84 / 411

Configuring the measurement setup
R&S
®
AREG800A
84 User Manual 1179.3615.02 ─ 01
User Delay ← Cable correction table
Requires "Source > User".
Sets a user-defined delay value.
Remote command:
[:SOURce<hw>]:AREGenerator:FRONtend:TRX<ch>|QAT<ch>:CABLecorr:
CONNector<di>:RX|TX:USER:DELay
on page 332
User Attenuation ← Cable correction table
Requires "Source > User" or "Source > s2p-File".
Sets a user-defined attenuation value.
Remote command:
[:SOURce<hw>]:AREGenerator:FRONtend:TRX<ch>|QAT<ch>:CABLecorr:
CONNector<di>:RX|TX:USER:ATTenuation
on page 332
s2p File ← Cable correction table
Requires "Source > S2P".
Opens a standard file-select dialog to load cable correction data from a file. Loaded
can be files with file extension
*.s2p
.
Remote command:
[:SOURce<hw>]:AREGenerator:FRONtend:TRX<ch>|QAT<ch>:CABLecorr:
CONNector<di>:RX|TX:USER:FILE
on page 332
6.3 Sensor configuration
Access:
► Select "Measurement Setup > Configuration > Sensor Config".
The "Sensor Config" tab of the "Measurement Setup" dialog opens.
Settings:
● Overview ................................................................................................................. 84
● Sensor settings ....................................................................................................... 86
6.3.1 Overview
Access:
► Select "Measurement Setup > Configuration > Sensor Config > Overview".
The "Overview" side-tab provides a list of sensors connected to the
R&S
AREG800A.
Sensor configuration