R&S AFQ100A
Alphabetical List of SCPI-Error Messages
1401.3084.32 9.3
E-3
Command protected (-203)
The desired command could not be executed as it was protected with a password.
Example:
The command
CAL:FREQ?
might be protected with a password.
Remedy
Use command
:SYST:PROT1 OFF
,
123456
to enable the command.
SCPI:
Execution error - sets bit 4 in the ESR register.
Data out of range (-222)
A value of the transmitted command was outside the legal range.
Example:
Command
SOUR:FREQ
only permits entries in the range of min to max
frequency.
SCPI:
Execution error - sets bit 4 in the ESR register.
Data type error (-104)
The command contains an invalid value indication.
Example:
ON is indicated instead of a numeric value for frequency setting -
:FREQ ON
SCPI:
Command error - sets bit 5 in the ESR register.
Device-specific error (-300)
Device-specific error not defined in greater detail.
SCPI:
Device-specific error - sets bit 3 in the ESR register.
Exponent too large (-123)
The magnitude of the exponent is too large.
SCPI:
Command error - sets bit 5 in the ESR register.
Expression data not allowed (-178)
The command contains a mathematical expression at an impermissible position.
SCPI:
Command error - sets bit 5 in the ESR register.
