R&S AFQ100A
Baseband Block
1401.3084.32 4.27
E-3
Marker Dialog
In the
Marker
dialog markers can be defined in addition to marker settings that may be defined already
in the waveform file. The marker dialog is accessed via the
Baseband
block.
In section
Reconfigure
up to four markers signals
can be set in addition to marker settings already
defined in the waveform file.
In section
Delay
the delay values for the marker
output signals are entered. Enters the delay between
the marker signal at the marker outputs and the start
of the signal.
In the
Delay
section a marker signal delay can be
defined, either without restriction or restricted to the
dynamic section. This means the section in which it is
possible to make settings without restarting signal
and marker output.
Note:
The curves plotted in this dialog box only are
textbook examples,
not measured
waveforms.
They are intended to visualize the trigger settings
more clearly.
Channel 1...4 - Marker
Selects the type of a marker signal on the appropriate marker output.
Note:
The marker trace in the waveform file remains unchanged in every
case. It is not overwritten, even in the case of a selection other
than
Unchanged
.
Unchanged
The marker signal is generated as defined in the
waveform file. It remains unchanged.
Remote-control command:
SOUR:TRIG:OUTP1:MODE UNCH
Restart
A brief marker pulse is released at the start of the
waveform or a segment.
Remote-control command:
SOUR:TRIG:OUTP1:MODE REST
