Update and restore
R&S
®
TSMA6B
90
User Manual 4901.4026.02 ─ 01
2. Press the [Shift] key and reboot the operating system.
3. The R&S TSMA6B reboots in the R&S recovery environment.
4. Select "Factory Default Restore".
5. Select "Start Recovery".
The R&S TSMA6B recovery starts and the "Mode" LED blinks green.
NOTE:
Do not interrupt the recovery process.
6. When the recovery has finished, press Exit/Reboot.
7. After the reboot, check if a microcontroller flash is performed (LED blue/green).
8.8
Usage of the R&S TSMA6B Image Stick
With the R&S TSMA6B image stick, you can capture images from and apply images to
another R&S TSMA6B.
Create a R&S TSMA6B Image Stick
.......................................................................90
Boot from the R&S TSMA6B Image Stick
...............................................................91
Capture an Image from a R&S TSMA6B
................................................................ 91
Apply an Image to a R&S TSMA6B
........................................................................ 93
8.8.1
Create a R&S TSMA6B Image Stick
To create a R&S TSMA6B image stick, proceed as follows.
Prerequisites:
●
A bootable USB stick (USB 3.1 Gen1) with a capacity of at least 64 GB. Make sure
that the data on the USB stick is no longer needed as it will be formatted during
process of R&S TSMA6B image stick creation.
●
Download the "R&S TSMA6 Image Stick" (
TSMA6_ImageStick-v<x.y>.zip
)
tool (
www.rohde-schwarz.com/software/tsmx
).
●
On a PC, unzip the file
TSMA6_ImageStick-v<x.y>.zip
to a directory of your
own choice. The extracted directory contains the
PrepareWinPEStick.exe
file.
1. Insert the USB stick into a free USB3.1 port of a PC.
2. Execute the
PrepareWinPEStick.exe
file in the directory, where you have
saved the file.
3. Select the USB stick via the "Removable Device Selection" drop-down box.
Usage of the R&S TSMA6B Image Stick