R&G Racing
Unit 1, Shelleys Lane, East Worldham, Alton, Hampshire GU34 3AQ.
Tel: +44 (0)1420 89007 Fax +44 (0)1420 87301
www.rg-racing.com
Email:
PAGE 3 OF 9
RAP0009
FITTING INSTRUCTIONS
•
Using the ignition key, remove the rear seat.
•
Disconnect the tail light connector as shown in picture 1.
•
As shown in picture 2, remove the 4x bolts securing the OEM license plate bracket using a 10mm
socket and wrench, then gently withdraw the unit and wiring.
•
On the OEM license plate bracket, remove the 6x screws arrowed in picture 3 using a T15 Torx
tool.
•
Gently split the OEM licence plate bracket, then disconnect the indicator connections from the sub-
harness visible in picture 4. Please note the orientation of the connectors as they need to be
reconnected at a later stage.
•
Remove the OEM indicators using a 13mm spanner to loosen the securing nuts arrowed in picture
4.
•
Fit the indicators of choice (R&G mini indicator product codes: RG370 for bulb type and RG371 for
LED type, or RG372 for the aero-shaped LED type) to the OEM license plate bracket and secure
using a 13mm spanner.
•
Fit an indicator connector
(item 1)
to the bullet connections of each new indicator, then plug the
other end of each connector into the relevant sockets on the original sub-harness.
•
Push a rubber bung
(item 2)
into the now redundant indicator locating holes on the license plate
bracket.
•
Refit license plate bracket and seat as original, then ensure the operation of all lights are correct
before riding.
CONSUMER NOTICE
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design
changes which do not diminish their performance or visual appeal and supplying them in such state shall conform to the order.
The Buyer acknowledges no representation or warranty (other than as to title) has been given or will apply to the Products other
than those in R&G’s order or confirmation and the Buyer confirms it has chosen the Products as being of merchantable quality
and suitable for its particular purposes. Where R&G fits the Products or undertakes other services it shall exercise reasonable skill
and care and rectify any fault free of charge unless the workmanship has been disturbed. The Buyer is responsible for ensuring
that the warranty on the motorcycle is not affected by the fitting of the Products. On return of any defective Products R&G shall
at its option either supply a replacement or refund the purchase money but shall not be liable if the Products have been modified
or used or maintained otherwise than in accordance with R&G’s or manufacturer’s instructions and good engineering practice or
if
the defect arises from accident or neglect. Other than identified above and subject to R&G not limiting its liability for causing
death and personal injury, it shall not be liable for indirect or consequential loss and otherwise its liability shall be limited to the
amounts paid by the Buyer for the Products or the fitting or service concerned. These terms do not affect the Buyer’s statuto
ry
rights.
R&G RETURNS POLICY (NON-FAULTY GOODS)
Returns must be pre-authorised (if not pre-authorised the return will be rejected). Goods may only be returned direct to us if
they were purchased direct from us (customer must prove if necessary). Otherwise to be returned to original vendor. Goods
must be in re-sellable condition, in the opinion of R&G. All returns are subject to a 25% restocking and handling fee (25% of the
