OCG0032
R&G Racing
Unit 1, Shelley’s Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
Email:
3
Page | 3
Picture 2
Picture 3
Picture 4
Picture 5
FITTING INSTRUCTIONS
Cut the silicon rubber ‘U’ channel into suitable lengths and using a small amount of suitable
adhesive fit to the oil cooler guard frame as shown in picture 1.
Remove the two bolts arrowed in picture 2 and remove the two side infill panels.
Remove the two bolts in positions arrowed in pictures 3 and 4.
Offer the oil cooler guard assembly into position and secure using the original bolts as shown
in pictures 3 and 4.
Refit the infill panels as original as shown in picture 5.
ISSUE 1 27/02/2018 (NSY)
CONSUMER NOTICE
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design
changes which do not diminish their performance or visual appeal and supplying them in such state shall conform to the order.
The Buyer acknowledges no representation or warranty (other than as to title) has been given or will apply to the Products other
than those in R&G’s order or confirmation and the Buyer confirms it has chosen the Products as being of merchantable quality
and suitable for its particular purposes. Where R&G fits the Products or undertakes other services it shall exercise reasonable
skill and care and rectify any fault free of charge unless the workmanship has been disturbed. The Buyer is responsible for
ensuring that the warranty on the motorcycle is not affected by the fitting of the Products. On return of any defective Products
