R&G LP0127BK, Инструкция по монтажу

Страница: 3 / 11

R&G Racing
Unit 1, Shelley’s Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301 www.rg-racing.com Email: info@rg-racing.com
Picture 5 Picture 6
FITTING INSTRUCTIONS

Raise the seat.

Remove the two push rivets as arrowed in picture 1.

Remove the two rubber shields/liners.

Disconnect the black wiring plug socket for the licence plate illuminator as shown in picture 2.

While supporting the original licence plate bracket remove the four nuts as arrowed in picture 3.

Gently remove the original licence plate bracket (please ensure the wiring plug socket does not get
snagged as the wire is pulled through the under-tray).

Take the R&G Licence Plate Bracket (item 1 – TB0127) and fit the license plate illuminators
(items 6), as shown in picture 4. You will have to join the two licence plate illuminator wires
together using the connectors supplied (please connect the two black wires together and the two red
wires together using the supplied bullet connectors). Use a small amount of superglue to stick the
light shrouds in position. (Please use the heat-shrink (item 2) to protect the new license plate
illuminator wires).

Cable-tie the wires neatly together on the underside of the tail tidy as shown in picture 4 using the
small holes provided.

Offer into position as shown in picture 5 while feeding the wires through the under-tray as original
(as shown in picture 6).

Secure in position using the four button head bolts from kit (item 3) and the original nuts.

To connect the licence plate illuminators we suggest reusing the original licence plate illuminator
plug socket and cut and shut the wires using the connectors supplied in the kit (it is a good idea to
check the operation of the licence plate illuminators at this stage).

Refit the two rubber shields/liners.

Refit the two push rivets as shown in picture 1.

Refit the licence plate (it may require drilling).

IMPORTANT: IF FITTING A FULL-SIZE LICENCE PLATE AND PLACING IT FAR DOWN ON THE
LICENCE PLATE HANGER, THERE IS A SMALL CHANCE OF THE LICENCE PLATE HITTING THE
BACK WHEEL UNDER HEAVY LOAD AND OVER LARGE BUMPS IN THE ROAD. IT IS YOUR
RESPONSIBILITY TO CHECK FOR THIS POSSIBILITY AND TAKE AVOIDING ACTION. FAILURE TO
CHECK THIS COULD RESULT IN SERIOUS INJURY.

Depending on local laws, attach enclosed reflector in an appropriate location.

Test the license plate illuminator and all lights before riding.
ISSUE 1 12/09/12 (NSY)