-Log Splitter Preparation Procedure-
The following items must be accomplished and checked before machine
operation.
Log splitter should be in a level position and used only out of doors, not in an
enclosed area.
Make sure all connections, lines and hoses are tight and not damaged before
filling with fluids.
When hooking up your Log Splitter Attachment insure all hoses are properly
tightened before turning on the Hydraulic power source.
Motor oil should be placed in the engine crankcase according to the instruc-
tions in the engine manufacturer’s instructional manual. Gasoline is then
put into the engine fuel tank according to the engine manufacturers operat-
ing manual. Standard fueling safety procedures must be followed during
refueling. DO NOT start the log splitter engine until hydraulic oil is added
to the hydraulic system.
When filling the hydraulic system of the log splitter with hydraulic oil, add
Dextron II or III or any light hydraulic oil, such as Mobil DTE 13M or
equivalent. Fill the hydraulic reservoir within 1 inch from the top of the res-
ervoir. Replace the reservoir cap.
Place the engine stop switch to the “OFF” position. Pull the engine cord over 4
or 5 times. Place the engine stop switch to the “ON” position. Pull the en-
gine cord and start the engine. Move the control lever to the forward extend
position and let the ram move ½ of its length. Stop the engine. Add hydrau-
lic oil to the hydraulic reservoir to within 1 inch of the top of the reservoir.
Start the engine. Move the control lever to the forward extend position and let
the ram move to the fully extended position. Reverse the control lever and
let the ram move to its full reverse position. Stop the engine. Check the hy-
draulic oil level and add to within 1 inch from the top of the reservoir as
needed. Cycle the ram forward and reverse several times until ram move-
ment is smooth and even. Do a final hydraulic oil check. Inspect all hoses,
lines and fittings for leakage. Correct any leakage before continuing usage.
Your Ramsplitter log splitter is now ready for service!
