Ramsey Electronics WSR-ANT, Сборка и инструкция по эксплуатации

Страница: 11 / 20

WSR-ANT
•
11
Stripping Coax cable for soldering
❍ 1. Make a slice using a sharp knife 3/4 inch back from the end of the
wire. Be careful not to cut through the wire underneath the insulation.
❍ 2. Pull the outer piece of insulation off, exposing the first layer of
shield wires.
❍
3. Pull all of these strands off to one side, then twist them together. If
you want at this point, you may solder these strands together.
❍
4. Using your sharp knife again, cut a slice around the inner
insulation about 3/8 inch back from the end of the wire.
❍
5. Pull the insulation off, and twist the wires together.
❍
6. You can now solder all of your connections
❒
6. You will want to perform the above process for both ends of
the RG-58U and the RG-62. It is important that the lengths of
the wires that are given to you remain the same as what is
provided, as changing the lengths will decrease the
performance of your project.
❒
7. If you are planning on using the WSR-LNA preamp, you will
need to solder one end of the RG-58U cable to the end of the
board marked ‘ANT’. Use a spare piece of uninsulated wire to
‘strap down’ the shield of the coax to the preamp PC board.