Ramsey Electronics WILDCAT 130K, Инструкция по эксплуатации, обслуживанию и ремонту

Страница: 6 / 28

4
CLUTCH OPERATION
WARNING:
CLUTCH MUST BE FULLY ENGAGED BEFORE STARTING THE WINCHING OPERATION.
To engage clutch:
1. Move clutch control to engage the clutch.
2. Run the motor in the cable out direction until the drum begins to turn.
WARNING: DO NOT DISENGAGE CLUTCH UNDER LOAD.
To disengage clutch:
1. Run the winch in the "cable out" direction until the load is off the cable.
2. Move the clutch control to disengage the clutch. The cable may now be spooled off.
WINCH OPERATION
The best way to get acquainted with how your winch operates is to make test runs before you use
it. Plan your test in advance. Remember, you hear your winch, as well as see it operate; learn to
recognize the sounds of a light steady pull, a heavy pull, and sounds caused by load jerking or
shifting. Gain confidence in operating your winch and its use will become second nature with you.
The uneven spooling of cable while pulling a load is not a problem, unless there is a cable pileup
on one end of drum. If this happens reverse the winch to relieve the load and move your anchor
point further to the center of the vehicle. After the job is done you can unspool and rewind for a
neat lay of the cable.
MAINTENANCE
Adhering to the following maintenance schedule will keep your winch in top condition and performing
as it should with a minimum of repair.
A. WEEKLY
1.
Check the oil level and maintain it to the oil level plug. If oil is leaking out, determine location and
repair.
2.
Check the pressure relief plug on the gear housing cover and the brake housing cover. Be sure they
are not plugged.
3.
Lubricate cable with light oil.
4. Lubricate drum bushings with grease. It is necessary to remove cable to expose the grease zerks on
drum. Use high quality lithium grease for best results.
5. Apply a high quality lithium grease to clutch spline. Apply band brake to control drum. Declutch drum
and apply grease to spline between clutch and drum.
B. MONTHLY
1.
Check the winch mounting bolts. If any are missing, replace them and securely tighten any that are
loose. Use grade 8 or better bolts.
2.
Inspect the cable. If the cable has become frayed with broken strands, replace immediately.
C. ANNUALLY
1.
Drain the oil from the winch annually or more often if winch is used frequently.
2.
Refill the winch to the oil level plug with all purpose GL-5 oil, (see page 5) for gear lube compatible with
your climate.
3. Inspect winch for damage and wear.