Ramsey Electronics BULLSHOOTER ENDLESS LOOP BS2C, Сборка и инструкция по эксплуатации

Страница: 23 / 28

BS2
•
23
button first and then try to select the location you’ll see letters on the display.
The letters indicate the volume level, as explained in the next section. Be sure
to select the location first before hitting PLAY. Now it does get a little more
complex if you want to replay the same message over and over again rather
than the default mode of play once only.
To change to the new repeat mode, power down the BS2C, and then power it
back up while holding the PLAY button down. The display will now show an “r”
to indicate repeat mode. Now you can select from a list of 16 different delays
you can use. See the following table:
The numbers 0 through 7 will set the delay time on the same memory location,
to repeat the same location over and over at a set time delay. The number 8
through the letter F will set the time delay between different memory locations.
For example, if you want to play through from message 1 to message 2 with a
certain time delay, set the time using that section of the chart. When you’ve
chosen your delay time, press the STOP button to save the setting. Also, don’t
forget that the delay time is the time you set
plus the time it takes for the mes-
sage to play. The delay time starts at the end of your message and repeats it
at your desired interval. The next interval will be the time you set in addition to
the time the message takes to run. For example, setting the time delay for 1
minute with a 30 second message will cause the message to be played after 1
minute and 30 seconds. Pretty simple, but something to keep in mind.
To turn the repeat mode back off again, turn off the BS2C, and then power it
back up while pressing just the RECORD key. The BS2C will go back to nor-
mal mode and save the settings.
Playback Volume
You can adjust the playback volume using the UP/DOWN buttons while the
BS2C is playing. You have 8 levels to choose from: L,A,B,C,D,E,F,H. H being
Delay time on same
message Time delay
0
0 seconds
1 0.5 seconds
2 5 seconds
3 30 seconds
4 1 minute
5 10 minutes
6 30 minutes
7
60 minutes
Delay time with incre-
ment message
8
9
A
b
C
d
E
F