FAILURE TO FOLLOW
INSTRUCTIONS CAN
CAUSE INJURY TO THE
TOOL OPERATOR OR
TO BYSTANDERS.
Fastener Driving Safety
1. Only use the tool for fastening into
a suitable base material.
2. Never fire the tool without a fastener.
Firing a tool without a fastener will
cause the piston to strike the work
surface, and may cause serious injury
to you and others in the work area.
3. Always use the spall guard whenever
possible to minimize flying particles
or debris.
4. Always hold the tool perpendicular
to and firmly against the work
surface when making a fastening.
Failure to do
so could allow a fastener
to ricochet.
5. Never attempt to drive a fastener
close to an edge or to another
fastener.
See page 8 for guidelines.
ALWAYS FOLLOW THE
MISFIRE PROCEDURE.
If the tool does not fire after the normal
firing sequence, continue to hold the
depressed tool against the work surface
for at least 30 seconds.
Then carefully lower
the tool, remove the strip load, and put it
in a can of water or other non-flammable
liquid. Never carelessly discard a strip with
live loads into a trash container.
If the tool becomes stuck or jammed with
a live powder load,
keep the tool pointed
in a safe direction, and immediately tag it,
“Danger- defective - do not use”.
Lock
the tool in a tool box and call your local
Ramset distributor for assistance.
SAFETY INSTRUCTIONS
DANGER
SAFETY INSTRUCTIONS
DANGER
6
USE SPALL GUARD WHENEVER POSSIBLE
ALWAYS HOLD THE TOOL PERPENDICULAR
TO THE WORK SURFACE
NEVER DRIVE A FASTENER CLOSE TO
AN EDGE
HOLD THE TOOL FIRMLY AGAINST
THE WORK SURFACE FOR AT
LEAST 30 SECONDS
SPALL
GUARD
90°
SA270_manual.qxd 11/21/06 1:01 PM Page 11
Содержание SA270
Страница 12: ...PARTS SCHEMATIC PARTS SCHEMATIC 12...
