Loco-1 / Loco-2
V1.1 - English
page 16 of 36
6
Decoder configuration/programming
6.1
Programming with a DCC Station
From the control center, you can program the configuration variables
(CV). Please refer to the relevant section in the user manual of your
control center, in which the byte-wise programming of CV variables is
described (Direct CV Addressing). The decoder allows programming
via POM (Programming on the main track) and the programming on a
programming track.
6.2
Programming with a Märklin
®
Station
Set the loco on a track, which is connected to the output of the
control center. Make sure that no other loco is on the track, because
otherwise the further present decoder may also be programmed.
Please note: If you have a control center that sends both the DCC
and Motorola format, the programming of the decoder in DCC format
is recommended. You can control the decoder after programming in
the Motorola format.
Perform a reset at the control center by pressing the "stop" and "go"
buttons at the same time for a longer time, or by turning the control
center off and on again. First select the current address or the
address
‘80' (if the current address is unknown). Make sure all
functions are switched off (function, f1 to f4 to "off"). Next, press the
"stop" button on the control panel. Then operate the direction switch
and hold it in this position while you turn on the control center via the
"go" button again.
