
Page 2 of 3
3
Figure 5
Front
DRIVER/LEFT FRONT MOUNT
Identify the driver/left side step.
The The front mount has a clearanced opening.
See Figure 5
4
Figure 6
Front
DRIVER/LEFT FRONT MOUNT
With assistance, hold the Driver/left Rail Side
Steps up in place against the back of the pinch
weld. Line up the (3) welded brackets with the
(6) factory holes in the pinch weld. Bolt the
brackets to the back of the pinch weld with the
included (6) 6mm x 25mm Hex Bolts, (12) 6mm
Flat Washers and (6) 6mm Nylon Lock Nuts.
Leave hardware loose at this time.
NOTE:
Insert Bolts from outside the pinch weld
and out through the Bracket.
Then bolt each top tab on the Trail Crawler Step
to the vehicle with the included (1) 8mm x 35mm
Hex Bolt, (1) 8mm Lock Washer and (1) 8mm
Flat Washer.
Leave hardware loose at this time.
See Figures 6 - 8.
8mm
Hardware
6mm
Hardware
Figure 7
Figure 8
DRIVER/LEFT FRONT MOUNT
DRIVER/LEFT REAR MOUNT