Fig. 4
How to save settings to memory.
Done! Blinking stops
1
2
3
4
FINISH
MEMORY
SAVE
3
HOLD
LEFT
1
2
3
4
Blinking starts
BEGIN
MEMORY
SAVE
1
HOLD
LEFT
SAVING PRESETS
Save settings to memory by holding the center toggle to the left twice: once to begin a save, and
once to end. Knobs can be adjusted before or during a save. Tap the left footswitch to exit a save.
Kismet has four memory positions to save presets. Each memory position saves all five
knob positions. Recall a memory position (Fig. 5) by tapping the left footswitch or the
center toggle switch. The internal resistances will be changed according to the saved
presets. LIVE SETTINGS indicates that all five knobs match the internal settings.
MEMORY INDICATION
The status of Kismet’s internal settings can
always be determined by the four bottom
LEDs and the LIVE SETTINGS LED. For
preset memories, the LEDs appear as seen
in Figure 3. The LIVE SETTINGS LED is lit
when all five knob positions match the
internal settings. When Kismet is bypassed,
the status LEDs will dim, but remain on.
Be aware that when Kismet is set to a
memory, its settings are changed internally
and may not match the physical knob
positions.
ALSO: the same LED indications are used
while saving (Fig. 4) except they will be
blinking.
1
2
3
4
LIVE SETTINGS
1
2
3
4
1
2
3
4
1
2
3
4
1
2
3
4
Fig. 3
LED indication of memory
ONE
TWO
THREE
FOUR
5
6
MEMORY
MEMORY
TAP
LEFT
TAP
RIGHT
Memory 3 selected
(for example)
1
2
3
4
SELECT
MEMORY
POSITION
2
NOTE:
Exit without saving at any time by pressing the left footswitch.
i
i
