RAM RAM 3500 2013, Руководство пользователя

Страница: 103 / 180

Audio
• Press and release the UP or DOWN arrow button until the Audio display icon is
highlighted in the EVIC. Press and release the RIGHT arrow button to display the
active source and the audio information.
Screen Setup
• Press and release the UP or DOWN arrow button until the Screen Setup display
icon is highlighted in the EVIC. Press and release the RIGHT arrow button to enter
the Screen Setup sub-menu. The Screen Setup feature allows you to change what
information is displayed in the instrument cluster as well as the location that
information is displayed.
UNIVERSAL GARAGE DOOR OPENER (HomeLink®)
• HomeLink ® replaces up to three hand-held transmitters that operate devices such
as garage door openers, motorized gates, lighting or home security systems.
The HomeLink
®
unit is powered by your vehicles 12 Volt battery.
• The HomeLink ® buttons that are located in the overhead console or sunvisor
designate the three different HomeLink ® channels.
• The HomeLink
®
indicator is located above the center button.
Before You Begin Programming HomeLink®
• Ensure that your vehicle is parked out-
side of the garage before you begin
programming.
• For efficient programming and accurate
transmission of the radio-frequency sig-
nal, it is recommended that a new bat-
tery be placed in the hand-held trans-
mitter of the device that is being
programmed to the HomeLink
® system.
• Erase all channels before you begin
programming. To erase the channels,
place the ignition switch into the ON/
RUN position, then press and hold the
two outside HomeLink
® buttons (I and III) for up to 20 seconds or until the red
indicator flashes.
NOTE:
Erasing all channels should only be performed when programming HomeLink
®
for
the first time. Do not erase channels when programming additional buttons.
• If you have any problems, or require assistance, please call toll-free 1–800–355–3515
or, on the Internet at www.HomeLink.com for information or assistance.
ELECTRONICS
101