RAM CHASSIS CAB 2024, Руководство пользователя

Страница: 32 / 360

Reclining The Seatback
The angle of the seatback can be adjusted forward or
rearward by using the power seat switch. The seat will
move in the direction of the switch. Release the switch
when the desired position is reached.
WARNING!
•
Adjusting a seat while driving may be dangerous.
Moving a seat while driving could result in loss of
control which could cause a collision and serious
injury or death.
•
Seats should be adjusted before fastening the seat
belts and while the vehicle is parked. Serious injury or
death could result from a poorly adjusted seat belt.
•
Do not ride with the seatback reclined so that the
shoulder belt is no longer resting against your
chest. In a collision you could slide under the seat
belt, which could result in serious injury or death.
CAUTION!
Do not place any article under a power seat or impede
its ability to move as it may cause damage to the seat
controls. Seat travel may become limited if movement is
stopped by an obstruction in the seat’s path.
Power Lumbar — If Equipped
Vehicles equipped with power driver or passenger seat
adjustments may also be equipped with power lumbar
adjustment. The power lumbar switch is located on the
outboard side of the power seat. Push the switch for-
ward to increase the lumbar support. Push the switch
rearward to decrease the lumbar support.
Easy Entry/Exit Seat — If Equipped
This feature provides automatic driver’s seat position-
ing to enhance driver mobility when entering and exiting
the vehicle.
The distance the driver’s seat moves depends on where
you have the driver’s seat positioned when you place
the vehicle’s ignition in the OFF position.
•
When you place the vehicle’s ignition in the OFF
position, the driver’s seat will move about
2.4 inches (6 cm) rearward if the driver’s seat posi-
tion is greater than or equal to 2.7 inches (6.77 cm)
forward of the rear stop. The seat will return to its
previously set position when you place the ignition
into the ACC or ON/RUN position.
•
When you remove the key fob from the ignition, the
driver’s seat will move to a position 0.3 inches
(0.77 cm) forward of the rear stop if the driver’s seat
position is between 0.9 inches and 2.7 inches
(2.27 cm and 6.77 cm) forward of the rear stop. The
seat will return to its previously set position when
you place the ignition to the ACC or ON/RUN
position.
•
The Easy Entry/Easy Exit feature is disabled when
the driver’s seat position is less than 0.9 inches
(2.27 cm) forward of the rear stop. At this position,
there is no benefit to the driver by moving the seat
for Easy Exit or Easy Entry.
When enabled in Uconnect Settings, Easy Entry and
Easy Exit positions are stored in each memory setting
profile
page 27.
NOTE:
The Easy Entry/Exit feature is enabled or disabled
through the programmable features in the Uconnect
system
page 165.
HEATED SEATS — IF EQUIPPED
On some models, the front and rear seats may be
equipped with heaters located in the seat cushions and
seatbacks.
WARNING!
•
Persons who are unable to feel pain to the skin
because of advanced age, chronic illness, diabe-
tes, spinal cord injury, medication, alcohol use,
exhaustion or other physical condition must exer-
cise care when using the seat heater. It may cause
burns even at low temperatures, especially if used
for long periods of time.
•
Do not place anything on the seat or seatback that
insulates against heat, such as a blanket or cush-
ion. This may cause the seat heater to overheat.
Sitting in a seat that has been overheated could
cause serious burns due to the increased surface
temperature of the seat.
Lumbar Control Switch
30 GETTING TO KNOW YOUR VEHICLE