Low-Pressure Transfer Pump
SER 3396101-1
7
Revision (8-06)
Air Piston
CAUTION
Use care not to switch Washers (4 and 8). Com-
ponent damage can occur.
9. Install Washer (
8
) [brass color] , O-Ring (
7
), and
Air Piston (
5
) (observe THIS SIDE UP] onto the
Rod.
10. Install Washer (
4
) [silver color] and Nut (
3
) that
secures the Air Piston to the Rod.
• Tighten the Nut securely.
• Place an appropriate size punch or other suitable
tool into the hole of the Rod.
11. Install Quad-Ring (
6
) onto the Air Piston.
Cylinder
12. Screw Cylinder (
25
) onto the Pump Body.
• Use care passing the O-Ring.
• Do not tighten at this time.
Stop and Valve Body Assembly
13. Install O-Ring (
12
) onto Valve Body (
28
).
14. Install Ball (
27
) and Stop (
26
) into the Valve Body.
• Make sure the Stop seats fully into the groove.
15. Screw the Valve Body assembly into the Cylinder.
• Use care passing the O-Ring.
16. Clamp the Valve Body securely in a soft-jaw vise.
17. Tighten the Pump Body securely into the Cylinder
and at the same time the Cylinder onto the Valve
Body.
• Use Bushing (
13
) as leverage.
Attach Air Motor to Pump Tube
18.Clamp the pump assembly in a soft-jaw vise at
Valve Body (
28
).
19. Install the
Bottom Cap
onto the Body.
20. Install O-Ring (
9
) onto the upper groove of the
Body.
CAUTION
Install the Cylinder with care. Damage to Quad-
Ring (6) and/or O-Ring (9) can occur.
HINT
: Angle the
Cylinder
on to the
Quad-Ring.
Figure 4
Pump Tube Assembly (w/o Air Motor) - Section View
Refer to
Figure 2
Parts List for Parts Identification
1-800-548-1191 - http://www.partdeal.com - [email protected]
