RAM 2500 2019, Руководство пользователя

Страница: 36 / 332

GETTING TO KNOW YOUR VEHICLE
34
The delay interval decreases as you rotate
the knob until it enters the low continual
speed position. The delay can be regulated
from a maximum of about 18 seconds
between cycles, to a cycle every one second.
The delay intervals will double in duration
when the vehicle speed is 10 mph (16 km/h)
or less.
Windshield Washers
To use the windshield washer, push the
washer knob, located on the end of the multi
-
function lever, inward to the second detent.
Washer fluid will be sprayed and the wiper
will operate for two to three cycles after the
washer knob is released from this position.
If the washer knob is depressed while in the
delay range, the wiper will operate for several
seconds after the washer knob is released. It
will then resume the intermittent interval
previously selected. If the washer knob is
pushed while in the off position, the wiper
will turn on and cycle approximately three
times after the wash knob is released.
To prevent freeze-up of your windshield
washer system in cold weather, select a solu
-
tion or mixture that meets or exceeds the
temperature range of your climate. This
rating information can be found on most
washer fluid containers.
Mist Feature
When a single wipe to clear off road mist or
spray from a passing vehicle is needed, push
the washer knob, located on the end of the
multifunction lever, inward to the first detent
and release. The wipers will cycle one time
and automatically shut off.
NOTE:
The mist feature does not activate the
washer pump; therefore, no washer fluid will
be sprayed on the windshield. The wash
function must be used in order to spray the
windshield with washer fluid.
Rain Sensing Wipers — If Equipped
This feature senses moisture on the wind -
shield and automatically activates the wipers
for the driver. The feature is especially useful
for road splash or overspray from the wind
-
shield washers of the vehicle ahead. Rotate
the end of the multifunction lever to one of
five settings to activate this feature.
NOTE:
This feature can be programmed through the
Uconnect system. Refer to “Uconnect
Settings” in “Multimedia” in the Owner’s
Manual for further information.
The sensitivity of the system can be adjusted
with the multifunction lever. Wiper delay
position 1 is the least sensitive, and wiper
delay position 5 is the most sensitive. Posi
-
tion 3 should be used for normal rain condi -
tions. Positions 1 and 2 can be used if the
driver desires less wiper sensitivity. Positions
4 and 5 can be used if the driver desires
more sensitivity. Place the wiper switch in
the O (off) position when not using the
system.
WARNING!
Sudden loss of visibility through the
windshield could lead to a collision. You
might not see other vehicles or other
obstacles. To avoid sudden icing of the
windshield during freezing weather, warm
the windshield with the defroster before
and during windshield washer use.
2019_RAM_2500_3500_UG_USA=GUID-8BBFE451-BF24-4E82-808A-AE2460D39A05=1=en=.book Page 34