RAM 2500 2019, Руководство пользователя

Страница: 170 / 332

STARTING AND OPERATING
168
If equipped with two AUX Cameras, you can
switch between each camera by then
pressing the AUX1 or AUX2 buttons on the
Trailer Camera display.
AUX1 Camera Button
AUX2 Camera Button
Deactivation
The AUX Camera is deactivated by pressing
the “X” in the upper right corner of the
touchscreen. This will return the display
back to the previously displayed screen.
NOTE:

If the AUX button is pressed and no AUX
Camera is connected, the touchscreen will
display a blue screen along with the
message “Camera System Unavailable.”
The screen can be exited out by pressing
the “X” in the upper right hand corner.
This will return the display back to the
previously displayed screen.

Zoom View is not available with the AUX
Camera feature.

The display will always default to the
Trailer Camera display (AUX 1).
SURROUND VIEW CAMERA
SYSTEM — IF EQUIPPED
Your vehicle may be equipped with the
Surround View Camera System that allows you
to see an on-screen image of the surroundings
and top view of your vehicle whenever the gear
selector is put into REVERSE or manually acti
-
vated via the Uconnect system. The top view of
the vehicle will show which doors are open. The
image will be displayed on the touchscreen
display along with a caution note “Check Entire
Surroundings” across the top of the screen.
After five seconds, this note will disappear. The
Surround View Camera System is comprised of
four sequential cameras located in the front
grille, rear tailgate and side mirrors.
NOTE:
The Surround View Camera System has
programmable settings that may be selected
through the Uconnect System. Refer to
“Uconnect Settings” in “Multimedia” for
further information.
When the vehicle is shifted into REVERSE,
the rear camera view and top view is the
default view of the system (Automatic Activa
-
tion).
When the vehicle is shifted out of REVERSE
(with camera delay turned on), the camera
image will continue to be displayed for up to
10 seconds after shifting out of REVERSE
unless the vehicle speed exceeds 8 mph
(13 km/h), the vehicle is shifted into PARK
or the ignition is placed in the OFF position.
There is a touchscreen button “X” to disable
the display of the camera image.
When the vehicle is shifted out of REVERSE
(with camera delay turned off), the surround
view camera mode is exited and the last
known screen appears again.
While the “Rear View” camera is displayed
and guide lines are enabled, active guide
lines are overlaid on the image to illustrate
the width of the vehicle, including the side
view mirrors and its projected backup path
based on the steering wheel position.
Different colored zones indicate the distance
to the rear of the vehicle.
2019_RAM_2500_3500_UG_USA=GUID-8BBFE451-BF24-4E82-808A-AE2460D39A05=1=en=.book Page 168