RAM 2500 2019, Руководство пользователя

Страница: 164 / 332

STARTING AND OPERATING
162
PARKSENSE REAR PARK
ASSIST — IF EQUIPPED
The ParkSense Rear Park Assist system
provides visual and audible indications of
the distance between the rear fascia and a
detected obstacle when backing up, e.g.
during a parking maneuver. Refer to “Park
-
Sense System Usage Precautions” in this
section for limitations of this system and
recommendations.
ParkSense will retain the last system state
(enabled or disabled) from the last ignition
cycle when the ignition is changed to the ON/
RUN position.
ParkSense can be active only when the gear
selector is in REVERSE. If ParkSense is
enabled at this gear selector position, the
system will remain active until the vehicle
speed is increased to approximately 7 mph
(11 km/h) or above. When in REVERSE and
above the system's operating speed, a
warning will appear within the instrument
cluster display indicating the vehicle speed
is too fast. The system will become active
again if the vehicle speed is decreased to
speeds less than approximately 6 mph
(9 km/h).
ParkSense Sensors
The four ParkSense sensors, located in the
rear fascia/bumper, monitor the area behind
the vehicle that is within the sensors’ field of
view.
The sensors can detect obstacles from
approximately 18 inches (45 cm) up to
79 inches (200 cm) from the rear fascia/
bumper in the horizontal direction,
depending on the location, type and orienta
-
tion of the obstacle.
NOTE:
If equipped as a dually, the ParkSense
system has six rear sensors to assist in detec
-
tion around the dually flares.
ParkSense Display
When the vehicle is in REVERSE, the
warning display will turn on indicating the
system status.
The system will indicate a detected obstacle
by showing a single arc in the left and/or
right rear regions based on the object’s
distance and location relative to the vehicle.
If an object is detected in the left and/or
right rear region, the display will show a
single solid arc in the left and/or right rear
region and the system will produce a tone. As
the vehicle moves closer to the object, the
display will show the single arc moving closer
to the vehicle and the tone will change from
a single 1/2 second tone to slow, to fast, to
continuous.
The vehicle is close to the obstacle when the
warning display shows one flashing arc and
sounds a continuous tone. The following
chart shows the warning alert operation when
the system is detecting an obstacle:
WARNING ALERTS
Rear Distance
(inches/cm)
Greater than
79 inches
(200 cm)
79-59 inches
(200-150 cm)
59-47 inches
(150-120 cm)
47-39 inches
(120-100 cm)
39-25 inches
(100-65 cm)
25-12 inches
(65-30 cm)
Less than
12 inches
(30 cm)
2019_RAM_2500_3500_UG_USA=GUID-8BBFE451-BF24-4E82-808A-AE2460D39A05=1=en=.book Page 162