RAM 2014 TRUCK 1500, Руководство пользователя

Страница: 156 / 630

Programming HomeLink
姞
Before You Begin
If you have not trained any of the HomeLink
威
buttons,
erase all channels before you begin training.
To do this, press and hold the two outside buttons for
20 seconds. The EVIC will display “CLEARING CHAN-
NELS”. Release the buttons when the EVIC message
states “CHANNELS CLEARED”.
It is recommended that a new battery be placed in the
handheld transmitter of the device being copied to
HomeLink
威
for more efficient training and accurate
transmission of the radio-frequency signal.
It is also advised to park outside the garage while
training.
•
Turn the ignition switch to the ON/RUN position.
•
Place the handheld transmitter 1 to 3 in (3 to 8 cm)
from the HomeLink
威
buttons while keeping the EVIC
display in view.
For optimal training, point the battery end of the
handheld transmitter away from the HomeLink
威
•
Simultaneously press and hold both the chosen
HomeLink
威
button and the handheld transmitter but-
ton until the EVIC display changes from “CHANNEL
# TRAINING” to “CHANNEL # TRAINED”.
Then release both the HomeLink
威
and handheld trans-
mitter buttons.
If the EVIC display states “DID NOT TRAIN” repeat
Step 3. If the signal is too weak, replace the battery in the
handheld transmitter.
It may take up to 30 seconds or longer in rare cases. The
garage door may open and close while you train.
154 UNDERSTANDING THE FEATURES OF YOUR VEHICLE