Final
Assembly
and
Wiring
————————————————————————————
Wire
the
Bottom
Panel
to
the
Back
Panel
————————————————————————————
Lay the back panel down adjacent to the bottom panel where it will be installed.
•
Dress the yellow 12V wire along the bottom edge of the panel towards the power
connector.
•
Dress all of the other wires along the bottom edge of the panel towards the opposite end
from the power connector.
Position the back panel on the back of the bottom panel and secure it with three 6-32 screws.
Trim the length of these wires as needed.
————————————————————————————
Wire the AC Power and Ground
1.
Dress the 11” loose green wire close to the chassis and connect it to the “chassis” pad on the
Active Output.
2.
Dress the 26” loose green wire close to the chassis and toward the front of the bottom panel.
3.
Dress the power cable that is connected to transformer pins 2 and 4 as follows:
•
Dress the cable to the edge of the panel.
•
Dress the white/black twisted pair along the edge of the bottom panel toward the back of
the panel.
•
Dress the black twisted pair along the edge of the bottom panel toward the front of the
panel.
4.
Connect the white/black cable to the power connector as follows:
•
Trim ½” from the end of the black wire.
•
Strip ¼” from the end of both wires and tin the ends.
•
Connect the white wire to the center pin.
•
Connect the black wire to the bottom pin.
————————————————————————————
23
