4
-
Step 1:
Welcome page, select “Next” to begin setup.
-
Step 2:
Set a Password, this will be used to login to the webpages. It will also be the
password used to login to the App if a password is required.
-
Step 3:
Set the House number of the HUB. This should match the Rasoft Pro project
file as defined in the “New Project Wizard”. It is important this is set up correctly at
this stage as it will define the House number for the rest of the system.
-
Step 4:
Select “Finish” to complete setup.
3.3 Managing the HUB House number
Using the HUB on the default House address of 1 is strongly discouraged. Leaving the
House number as 1 drastically increases the likelihood of interface from nearby Rako
systems.
The HUB always has a
default House Address of 1
if it has not been set up before
.
Before
programming using the HUB it is important to ensure the HUB House number corresponds
to the Project file House number.
To change the House number if the HUB has already been set up as described in 3.2 see
below:
WK-HUB
Manual Version 1.3.4
