Issue A Jan 2012
Page 5 of 7
A Message will pop up in Rasoft to acknowledge
that the WAVMI is in Setup Mode.
Press the
Yes
button to continue.
Add the WAVMI to the system
. Give the
WAVMI a room number and name. Then press
Add
button followed by
Quit
The room number itself is not too important. Much more
important is that the WAVMI has its own unique identity.
It must not exist with the same
Device Number
as a
different device (WallPlate, RakLink etc) that is in the
same logical room. The Advanced Options check box will
allow manual setting of Device Number if this is proving
to be a problem
Wired Volt Free Setup screen will be shown:
Press
Update List
Button
to make the new WAVMI appear on list at bottom LH Corner. (The Default
WAVMI can be deleted from the list).
The new WAVMI should now appear as On-line. If it does
not, try Updating the List again, or even closing &
reopening this setup screen (Under
Controls-Wired-
WAVMI
tab)
