WISNODE-UART WIFI EVB QUICK START GUIDE
Copyright © Shenzhen Rakwireless Technology Co., Ltd
ETDX1701061900
4
Slots Usage：
（1）When WisNode-UART WIFI EVB used independently or as a host：Using H1，H2，H3，H4；
（2）When WisNode-UART WIFI EVB as a slave or plugged into other Arduino board：Using P4，P5，P6，P7
Serial Port connect methods：
（1）When WisNode-UART WIFI EVB used independently or as a host：RXD connect to CTX,TXD connect to CRX；
（2）When WisNode-UART WIFI EVB as a slave or plugged into other Arduino board：RXD connect to TX，TXD connect
to RX；
WPS/MODE key: By default, mode_pin does not enable, short press the button can make the module into the WPS
function, can be configured to have WPS function on the router;
Set the mode_pin enabled, then long press the key to maintain a low level state by the transparent transmission
mode module will enter the AT command mode, let go restore high level, module exit AT command mode in transmission
mode;
EASYCONFIG/DEFAULT key: Press the button to enter a key configuration function, with our APP can configure the
module to the designated router;
Long press the button is greater than 3S, the module will restore the factory settings;
图 1-4 WisNode-UART WIFI EVB Linking Methods
